Skip to main content
Skip table of contents

MultiTech Ethernet Gateway

Activation

  1. Using the network cable, connect the gateway to your network so that it can access the Internet.

  2. Connect power to the gateway. The Status indicator will change to green while the device is powering up.

  3. After a few moments the LoRa indicator will change to green and the Status indicator will flash briefly during activity. Your gateway is now ready for use.

Installation

Reset

In the event your device is offline or you need to reset it, please follow these steps.

  1. Disconnect power from the gateway and then wait several seconds.

  2. Reconnect power to the gateway. The Status indicator will change to green while the device is powering up.

  3. After a few moments the LoRa indicator will change to green and the Status indicator will flash briefly during activity. Your gateway is now ready for use.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.