Skip to main content
Skip table of contents

RisingHF RHF1S001 Temperature/Humidity

Activation

  1. Remove the battery cover and insert the ER34615 battery. The status indicator will briefly flash red.

  2. Your sensor is now ready for use.

Reset

In the event your device is offline or you need to reset it, please follow these steps.

  1. Remove the battery cover and take the ER34615 battery out of the sensor.

  2. Wait several seconds and then reinsert the ER34615 battery into the sensor. The status indicator will briefly flash red.

  3. Your sensor is now ready for use.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close