The following provides instructions on how to activate and install your Water Leak sensor after adding it to your account with an online gateway.
Installation Video
Drip Sensor
-
The top of the Leak Detector is shaped like a “sink” to direct the smallest amounts of water that drips from above to the Drip Sensor.
-
To use the Drip Sensor, place the Water Detector directly underneath drains, pipes, or anything else that might spring a leak
-
The cutout along the straight side of the Leak Detector allows the sensor to be placed along a wall, even with quarter-round molding
Bottom Sensors
-
The bottom of the Leak Detector has three pairs of metal leads, that each act as separate sensors
-
To use the bottom sensors, place the Leak Detector on a at surface where you expect water to pool in the event of a leak
Remote Sensor Probe
-
The Remote Sensor Probe has an extremely small form factor to fit underneath appliances and in other tight spaces
-
To use the Remote Sensor Probe, plug the 3.5mm plug into the jack on the Leak Detector, and place the Probe where you would like to monitor for water
-
The Probe can be placed on a surface or it can oat in a container (e.g. in a sump pump)
-
The Remote Sensor Probe can be used simultaneously with the Bottom Sensors and the Drip Sensor
-
The Leak Detector has magnets inside to optionally attach the Leak Detector to any magnetic surface while using the Remote Sensor Probe